Uniflair WMA 0281 Instrukcja Instalacji Pobierz pdf (Strona 12)

INSTALLATION

Wall Mounted 0121…0661

12 (22)

Monobloc Wall Mounted Unit - WMA/WMF 0121-0181-0251-0281-0331-0551-0661 - Rev. 2.0. - Date: 18-07-2000 EN

Fix rubber seals around the mouths of the air intake and discharge to ensure an airtight fit; 18-20mm thick self-

adhesive closed-cell neoprene rubber tape is recommended.

Apply a layer of builder’s silicone to the joint between the top cover of the unit and the wall, to prevent rain from

entering the gap.

NEOPRENE

TAPE

SILICONE

SEALANT

Fig. 10

EXTERNAL AIR INTAKE (0121…0331 models)

WM 0121…0331 units are available in the following versions with different

external air intakes:

• WMA; the lower front panel is completely closed (fig. 11. - panel C);

• WMF, with external air intake for the free-cooling cycle and motorised

control damper.

The quantity of external air is variable from a minimum value (set using

the microprocessor control) to 100% of the air discharged into the air

conditioned environment. It is taken in via a special opening mounted

on the front panel (fig. 11. -panel C2) - which contains a washable

metal pre-filter to protect against the entry of leaves and insects.

The expulsion of air from the air conditioned environment is via an

aperture connected to the lower lateral grilles (D).

Fig. 11

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 21 22

Brak uwag

Uniflair WMA 0281 Instrukcja Instalacji Strona 12